Quality of tiara (LLDPE)
Jogmaiyya Polymers ‘TIARA’ tanks are made from LLDPE, which is the main polymer used. The tanks are moulded by Rotational Moulding process whereby the residual stress is negligible. The production methods used at our factories are highly controlled and amongst the best. Moreover, these methods involve better process ability ensuring low shear rates, high impact strength and rigidity.
Why JOGMAIYYA POLYMERS Products?
What is the life expectancy of Tiara tank?
- The most common reason for pre-mature tank is poor installation.
- Piping connections on the tanks must be adequately supported with pipe supports and expansion joints or flexible connections to allow for thermal expansion and normal flexing of the tank wall.
- Installing the tank on a surface with foreign materials under the tank will puncture it when the tank is filled.
- The tank must be installed on a clean, flat surface and be fully supported to prevent the tank from sagging, which will create a shear point and ultimately a leak.
- Tank should never be hung over the edge of a tank pad without ancillary support.
- Installing heavy equipment directly on the tank without adequate external support or reinforcement can also cause the tank to fall prematurely.
Common do’s & don'ts with ‘TIARA’ storage tank
- Do not over tighten tie down straps or bands which may cause excessive stress on the tank. A “snug” fit is the best.
- Do not attach heavy valve and plumbing fittings on a bulkhead fitting without proper support. Always use flexible connections to allow the tank to expand and contract.
- Always water test the tank before using to ensure the fittings are sealed tight.
- Do not over-tighten the bulkhead fittings. Fittings are installed to proper torque ratings at the time of manufacturing but may become loose through movement in shipping. When you get your tank, hand-tighten the fitting and then give it ¼ of a turn to make sure it is tight.